MIXER Panel

EFFECT : These knobs specify how much EFFECT is being applied to each part.
PAN : These knobs control the PAN (Left/Right stereo positioning) of each part.
MUTE : Use the MUTE button to momentarily silence any part(s) and remove it from the mix.
SOLO : Use the SOLO button to isolate a specific part, and to MUTE all of the other parts.
LEVEL : These faders allow you to set the level for each part.
The red LED indicates the signal is clipping, or overloading the input and may cause distortion.


EFFECT      

TYPE : Use this knob to select the type of effect. Select “OFF” if you don’t want to use an effect.
EDIT1 : This knob edits a specific parameter of the chosen effect. The parameter differs depending on the effect.
EDIT2 : This knob edits a specific parameter of the chosen effect. The parameter differs depending on the effect.
MASTER : The Master fader sets the overall output level of the MIXER section.

 

 

 

 

Was this article helpful?
1 out of 1 found this helpful

Comments

Please sign in to leave a comment.